TL;DR
- VA rates hypertension under diagnostic code 7101 at 10%, 20%, 40%, or 60%, based mainly on diastolic pressure (38 CFR 4.104).
- Diastolic predominantly 100 or more, or systolic predominantly 160 or more, meets the 10% level. Diastolic predominantly 130 or more is the top level at 60%.
- If you have a history of diastolic readings predominantly 100 or more and need continuous medication for control, the minimum is 10%.
- The diagnosis must be confirmed by readings taken two or more times on at least three different days (38 CFR 4.104, Note 1).
- Hypertensive heart disease and other heart disease are rated separately from hypertension (38 CFR 4.104, Note 3).
The VA rating for hypertension runs from 10% to 60% under diagnostic code 7101. VA looks mainly at your diastolic pressure, the bottom number. Diastolic pressure predominantly 130 or more meets the 60% criteria, while diastolic predominantly 100 or more, or systolic predominantly 160 or more, meets the 10% criteria (38 CFR 4.104).
There is also a 10% minimum for veterans who have a history of diastolic readings predominantly 100 or more and who require continuous medication for control (38 CFR 4.104). Below, we break down every level, the multiple-reading rule, how heart problems fit in, and what our sources do and do not cover on PTSD, kidney links, and the PACT Act.
What blood pressure numbers match each hypertension rating?
Here is the full rating table for diagnostic code 7101, "Hypertensive vascular disease (hypertension and isolated systolic hypertension)" (38 CFR 4.104).
| Rating | Diastolic (bottom number) | Systolic (top number) | Other route |
|---|---|---|---|
| 60% | Predominantly 130 or more | Not listed | None |
| 40% | Predominantly 120 or more | Not listed | None |
| 20% | Predominantly 110 or more | Predominantly 200 or more | None |
| 10% | Predominantly 100 or more | Predominantly 160 or more | History of diastolic predominantly 100 or more, plus continuous medication required for control |
Notice that systolic pressure only counts at the 10% and 20% levels. To reach 40% or 60%, the diastolic number has to carry the load (38 CFR 4.104).
For dollar amounts at each combined rating, check the VA disability pay chart for 2026.
What does "predominantly" mean for my readings?
Every level in the table uses the word "predominantly" (38 CFR 4.104). In plain English, the word means mostly, so the focus is on your usual readings, not one spike on a bad day.
Here is a simple illustration, not a prediction. Say your readings mostly sit around 150 over 112, with a few at 150 over 98. Most of your diastolic numbers are in the 110s, which matches the wording of the 20% level.
One reading at 125 diastolic would not, by itself, show that 120 or more is your main pattern. This works both ways: one good reading on a single day does not tell the whole story either. That is why your full treatment records matter.
How many blood pressure readings does VA need to confirm hypertension?
The rule is specific. Hypertension or isolated systolic hypertension must be confirmed by readings taken two or more times on at least three different days (38 CFR 4.104, Note 1).
So think of it as a minimum of six readings across three separate days. One clinic visit, even with several checks, happens on only one day, so it does not meet the rule on its own.
The regulation also defines the terms (38 CFR 4.104, Note 1):
- Hypertension means diastolic pressure predominantly 90mm or greater.
- Isolated systolic hypertension means systolic pressure predominantly 160mm or greater, with diastolic pressure under 90mm.
Here is the catch. Diastolic predominantly 90 to 99 meets the definition of hypertension, but it falls short of the 10% diastolic threshold of 100 (38 CFR 4.104). If that is your pattern, the 10% level would have to come from the systolic route or the medication route.
I take blood pressure meds. Can I still get a 10% rating?
Medication can bring readings down, so your current numbers may sit well under 100 diastolic. The rating schedule accounts for this.
The 10% level includes a minimum evaluation for someone with a history of diastolic pressure predominantly 100 or more who requires continuous medication for control (38 CFR 4.104). Two pieces have to be there:
- The history. Your records need to show diastolic readings predominantly 100 or more at some point, usually before medication brought them down.
- The medication. You need to require continuous medication to keep your pressure under control.
If your diastolic history never ran predominantly 100 or more, this route does not apply as written. Your records decide this, so review your actual readings with an accredited VSO, agent, or attorney.
A practical tip: dig up the earliest readings that led to your diagnosis. Old service treatment records, sick call notes, and civilian doctor visits before you started medication are often where the "history" lives.
What if my heart is involved too?
Hypertension and heart disease are rated as separate conditions. The regulation says to evaluate hypertension separately from hypertensive heart disease and other types of heart disease (38 CFR 4.104, Note 3).
VA proposed this clarification back in 2002, explaining that hypertension would be evaluated separately from hypertensive and other types of heart disease (67 FR 54394). Today, that separate-rating rule appears as Note 3 under DC 7101 (38 CFR 4.104).
Hypertensive heart disease has its own code, DC 7007. Heart diseases are rated under the General Rating Formula for Diseases of the Heart unless directed otherwise (38 CFR 4.104). That formula looks at METs, a measure of how much physical work you can do before symptoms hit:
| Rating | General Rating Formula for Diseases of the Heart |
|---|---|
| 100% | Workload of 3.0 METs or less results in heart failure symptoms |
| 60% | Workload of 3.1 to 5.0 METs results in heart failure symptoms |
| 30% | Workload of 5.1 to 7.0 METs results in heart failure symptoms; or cardiac hypertrophy or dilatation confirmed by echocardiogram or equivalent |
| 10% | Workload of 7.1 to 10.0 METs results in heart failure symptoms; or continuous medication required for control |
Heart failure symptoms include, but are not limited to, breathlessness, fatigue, angina, dizziness, arrhythmia, palpitations, or syncope (38 CFR 4.104, General Rating Formula, Note 3). If METs testing cannot be done for medical reasons, an examiner may estimate your METs level using examples like slow stair climbing or shoveling snow (38 CFR 4.104, General Rating Formula, Note 2).
VA revised the cardiovascular section of the rating schedule in a final rule effective November 14, 2021 (86 FR 54089). If you have an older rating decision, it may use language from before that revision.
What if my high blood pressure is caused by another condition?
The rating schedule addresses one version of this directly. Hypertension due to aortic insufficiency or hyperthyroidism, which is usually the isolated systolic type, is evaluated as part of the condition causing it, not as a separate rating (38 CFR 4.104, Note 2).
Many veterans also ask about high blood pressure linked to PTSD, or kidney problems tied to high blood pressure. The sources behind this page cover the rating table in 38 CFR 4.104, not the medical or legal rules for those specific links. We are not going to guess.
For how secondary service connection works in general, read our guide to VA secondary conditions. For conditions connected to PTSD, see our page on PTSD secondary conditions. Your own doctor is the right person to weigh in on what is causing your blood pressure.
If PTSD is weighing on you right now, the Veterans Crisis Line is there: dial 988 then press 1, text 838255, or chat at VeteransCrisisLine.net.
Is hypertension a PACT Act presumptive condition?
This is a fair question, but the sources we used for this page cover how hypertension is rated, not presumptive service connection rules. So we will not state an answer here rather than guess.
Read our PACT Act presumptive conditions page, and confirm your own service history with an accredited VSO, agent, or attorney. However service connection is established, the rating level for hypertension itself comes from the DC 7101 table above (38 CFR 4.104).
How do I build strong evidence for a hypertension claim?
Step 1: Gather your readings from every source
Pull service treatment records, VA medical records, and private doctor records. You want enough readings to show your usual pattern and to meet the two-readings, three-days rule (38 CFR 4.104, Note 1).
Step 2: Find your pre-medication history
If you are on meds, locate readings from before treatment started. This is what supports the history of diastolic predominantly 100 or more needed for the medication route to 10% (38 CFR 4.104).
Step 3: Document your medication
Make sure your records clearly show you need continuous medication for control. A current medication list from your provider helps.
Step 4: Prepare for the C&P exam
Bring your medication list and any readings you have gathered. Be honest, and do not skip your prescribed medication to push your numbers higher. Our C&P exam tips page covers what to bring and what to expect.
If you want a full walkthrough of the exam, our C&P Exam Prep Kit ($47) lays it out step by step.
Step 5: Ask about any heart involvement
If you have shortness of breath, chest pain, or other heart symptoms, raise them with your provider. Heart disease is rated separately from hypertension (38 CFR 4.104, Note 3), so it should not be lumped in.
What should I do next?
Line up your readings against the DC 7101 table and see which level your pattern actually matches. If you are already rated and your numbers have climbed, read our guide on how to increase your VA disability rating.
To see where your current rating may fall short of what the criteria describe, run the Rating Gap Check. Then take your records to an accredited VSO, agent, or attorney to confirm your next move.
Frequently asked questions
What is the highest VA rating for high blood pressure alone?
The highest level under diagnostic code 7101 is 60%. It requires diastolic pressure predominantly 130 or more (38 CFR 4.104). Heart disease is evaluated separately from hypertension (38 CFR 4.104, Note 3).
Does a systolic reading of 160 get a VA rating?
Systolic pressure predominantly 160 or more meets the 10% level under DC 7101. Systolic predominantly 200 or more meets the 20% level (38 CFR 4.104). Systolic numbers alone do not reach 40% or 60%.
Do I need multiple blood pressure readings for a VA hypertension claim?
Yes. The regulation requires readings taken two or more times on at least three different days to confirm hypertension or isolated systolic hypertension (38 CFR 4.104, Note 1). One visit is not enough on its own.
Can I get a VA rating if my blood pressure is controlled with medication?
Possibly. DC 7101 sets a 10% minimum if you have a history of diastolic pressure predominantly 100 or more and need continuous medication for control (38 CFR 4.104). An accredited VSO, agent, or attorney can review whether your records show that history.
Is hypertensive heart disease rated the same as hypertension?
No. Hypertension is evaluated separately from hypertensive heart disease and other heart diseases (38 CFR 4.104, Note 3). Hypertensive heart disease is listed under DC 7007, and heart diseases use the General Rating Formula for Diseases of the Heart unless directed otherwise.
What counts as hypertension for VA purposes?
VA defines hypertension as diastolic blood pressure predominantly 90mm or greater. Isolated systolic hypertension means systolic predominantly 160mm or greater with diastolic under 90mm (38 CFR 4.104, Note 1).
Sources
- 38 CFR 4.104, cardiovascular system (LII / Legal Information Institute)
- eCFR: 38 CFR 4.104, Schedule of ratings, cardiovascular system
- Federal Register: Schedule for Rating Disabilities: The Cardiovascular System
- Federal Register: Schedule for Rating Disabilities; Guidelines for Application of Evaluation Criteria for Certain Respiratory and Cardiovascular Conditions; Evaluation of Hypertension With Heart Disease